Install SD Card Into a Turret Camera
On your VIP VISION CCTV camera, locate the ‘RESET’ cover.
Unscrew the cover revealing the RESET button as well as where you will be putting the SD card.
Insert the SD card into the designated slot, it can only go in one way which is the front facing the same direction as the camera.
Once the SD card is in the slot push it down until you hear a faint clicking noise and the card is no longer sticking out.
The SD card is now officially installed, screw the ‘RESET’ cover back on and you will be done.
Install SD Card into a Bullet Camera
1. On your VIP VISION CCTV camera, locate the large cover on the underside of the camera.
2. Unscrew the cover revealing the inside of the camera as well as the designated spot for the SD Card.
3. Insert the SD Card into the designated spot, it can only go in one way.
4. Push the SD Card in until you hear a faint click and the card is only just sticking out.
5. The SD card has now been officially installed, you can now put the cover back on closing the camera.
Install SD Card into a Dome Camera
1. On your VIP VISION CCTV Camera remove each of the screws and remove the top dome.
2. Once open, locate the designated spot for the SD Card underneath the camera.
3. Slide the SD Card holder towards where the screw was to open it.
4. Place the SD Card inside the designated spot, it will only fit one way, and close it, you then must push it the opposite direction so it is locked.
5. The SD Card is now officially installed, put the dome back onto the camera and screw it in, you are done.
