Cornick Help Center

    Default a WGAP864WRX2 to factory settings

    To learn on how to default the wireless remote receiver.

     

    The WGAP864WRX2 leaves the factory with its memory empty.
    The WGAP864WRX2 restores its default configuration whenever it finds its memory empty at start up.

     

    The steps to default the wireless remote receiver are as follows:

     

    1. Remove power from the receiver
    2. Flip all dipswitches in the ON position.
    3. Power up the receiver and wait for 10 sec.
    4. When this is done, the receiver clears its memory then waits with the red LED quick-flashing in groups of three
    5. Set all dipswitches in the OFF position, except for the ones you need ON to address the receiver.
    6. Now, the remote receiver then restarts normally

    Was this article helpful?

    Send feedback

    Can’t find what you’re looking for?

    Our customer care team is here for you.

    Contact Support