Cornick Help Center

    2-Wire Intercoms - Wiring for new and existing systems

    March 14th, 2023

    3rd Generation 2-Wire

    How to identify a Gen.3 INTIPRDSG

    Both the box and the product label of the INTIPRDSG will have "GEN.3" written on it to identify that it is a Generation 3 INTIPRDSG. If it does not have this, it is a Generation 2 INTIPRDSG.

    Delete

    3rd Generation 2-Wire Wiring

    Delete

    3rd Generation 2-Wire plus IP Intercom Products Wiring


    Delete

    2nd Generation 2-Wire

    2nd Generation 2-Wire Wiring

    • One Monitor or Door Station per 2-Wire terminal on the INTIPPOE2W (Cannot be daisy chained)

    • If you have more than 6 devices, connect a second INTIPPOE2W via the in/out ports.

    Delete

    2nd Generation 2-Wire plus IP Intercom Products Wiring

    • One Monitor or Door Station per 2-Wire terminal on the INTIPPOE2W (Cannot be daisy chained/cascaded)

    • If you have more than 6 devices, connect a second INTIPPOE2W via the in/out ports.

    • Connect a POE Switch to the LAN port of the INTIPPOE2W to add IP Door Stations & Monitors

    • INTIPRDSG & INTIPMONGW are used in the above example, but any current line Door Station or Monitor will work.

    Delete

    1st Generation 2-Wire

    1st Generation 2-Wire Wiring

    Delete

    Additional/replacement SIP Door Station or Monitor via Cat5e cable


    • Existing 2-Wire INTIPRDSVW2W and INTIPMONFB2W will need to be upgraded to SIP Firmware to work. INTIPRDSVW2W will have Chinese accented voice.

    • Connect a POE Switch to the LAN port of the Network Controller to power the new Intercom Products.

    • Any IP Door Station from the current range can be used in place of the INTIPRDSG

    • Any IP Monitor from the current range can be used in place of the INTIPMONGW

    Delete

    Combining Multiple Generations

    Additional/replacement 2nd and 3rd Generation Door Station or Monitor via 2-Wire cable.

    When connecting multiple generations of 2-wire each generation must be connected to its corresponding network controller i.e INTIPMON2W (Gen 2) must be connected to INTIPPOE2W (Gen 2) not INTIPPOE2W2 (Gen 3) or INTIPNC2W (Gen 1).

    • Generation 1:

      • Existing 2-Wire INTIPRDSVW2W and INTIPMONFB2W will need to be upgraded to SIP Firmware to work.

      • INTIPRDSVW2W will have Chinese accented voice.

    • Generation 2:

      • One INTIPRDSG/INTIPMON2W can be connected per port on the INTIPPOE2W

      • Multiple INTIPPOE2W can be connected via 2-Wire on the In/Out ports.

    • Generation 3:

      • All intercoms connect to the "out" port on the INTIPPOE2W2

      • Multiple INTIPPOE2W2 can be connected via 2-wire on the Up/Down ports.

    Delete

    Was this article helpful?

    Send feedback

    Can’t find what you’re looking for?

    Our customer care team is here for you.

    Contact Support